Selectable Self Tests - HP 1652B Getting Started Manual

When the power-up self testing is complete, the operating system will
be automatically loaded. If the operating system disk is not in the disk
drive, the message "SYSTEM DISK NOT FOUND" will be displayed
at the bottom of the screen and "NO DISK" will be displayed in front of
disk test in place of "passed."
-
If the "NO DISK" message appears, turn off the instrument, insert the
operating system disk into the disk drive, and apply power again.
Selectable Self
The following self tests may be accessed individually in the Self Test
Tests menu:
l
Analyzer Data Acquisition
l
Scope Data Acquisition
l
RS-232C
a BNC
l
Keyboard
0 RAM
l
ROM
l
Disk Drive
0 Cycle through tests
To select a test, place the cursor on the test name and press SELECT.
A pop-up menu appears with a description of the test. The self test
does not begin until the cursor is placed on Single or Repetitive Test
and the SELECT key is pressed.
When the test is complete, either "Passed","Failed", or "Tested" will be
displayed in the Self Test menu in front of the test. These tests are also
used as troubleshooting aids. If a test fails, refer to Section 6 of the
Service manual for information on the individual tests used for
troubleshooting.
Operator Self Test HP
16528/1653B
E-2
Front-Panel Reference