Error Messages; Introduction - HP 1652B Getting Started Manual

C
Introduction
This appendix lists the error messages that require corrective action to
restore proper operation of the logic analyzer. There are several
messages that you will see that are merely advisories and are not listed
here. For example, "Load operation complete" is one of these
advisories.
The messages are listed in alphabetical order and in bold type.
Acquisition aborted. This
acquisition is stopped.
message is displayed whenever data
At least one edge is required. A state clock specification requires at
least one clock edge. This message only occurs if you turn off all edges
in the state clock specification.
Autoload file not of proper type. This message is displayed if any file
other than an HP 1652B/1653B configuration file is specified for an
autoload file andthe logic analyzer is powered up.
Autoscale aborted. This message is displayed when the STOP key is
pressed or if a signal is not found
15
seconds after the initiation of
autoscale.
BNC is being used as an ARM IN and cannot be used as an ARM
OUT. This message is displayed when BNC arms machine
1
(or
2),
machine 1 (or 2) arms machine 2 (or l), and the BNC is specified as
ARM OUT. It will not occur if BNC arms machine
1
(or 2), and
machine
1
(or 2) arms BNC.
HP 1652B/1653B
Front-Panel Reference
Error Messages
C-1