Re-Acquiring The Data; Mixed Mode Display - HP 1652B Getting Started Manual

Re-acquiring
the Data
After you connect the probes of pods
4
and 5 to your circuit, all you
have to do is press RUN. When the logic analyzer acquires the data it
switches the display to the State Listing menu unless you switched one
of the other menus to the timing analyzer after reconfiguring the State
Trace menu. Regardless of which menu is displayed, change the display
to the Mixed Mode.
Mixed Mode
The Mixed mode display shows you both the State Listing and Timing
Display
Waveforms menus simultaneously. To change the display to the Mixed
Mode:
1. Place the cursor on the field in the upper left corner of the display
and press SELECT.
2. Place the cursor on Mixed Mode and press SELECT. You will
now see the mixed display as shown:
Inl~ea note]- Display
6eOOOST~lE- State
Ustug
I
0004F4 I .24 us
I
8 I+ooooJ +ooc2 woo3 -000 +ooo 1 I 0004F6 008930 008932 008934 008936 803C 8930 OOFF 67Ff3 803C I I.24 I I I .24 .24 .26 .24 us us US us us
6BOOOlItWB
- Timing Ww8forms X
to
Trigger 0 s
Tlme/Div 1 500 ns 1 Delay [ 0 6 ] 0 to Trigger 0 6
,
6
\
1 I I 1 r I
Figure
21-10.
Mixed Mode Display
Timing/State Measurement Example
21-12
HP 16528/1653B
Front-Panel Reference
-