HP 1652B Getting Started Manual page 269

c. With the Alpha
Entry
pop-up, change the name of the label to
ADDR.
d. Name the second label DATA by repeating steps a through c.
3. Assign Pod
1
bits 0 through I.5 to the label
DATA.
a. Place the cursor on the bit assignment field below Pod
1
and to
the right of
DATA
and press
SELECT.
b. Any combination of bits may already be assigned to this pod;
however, you will want all
16
bits assigned to the DATA label.
The easiest way to as&n is to press the CLEAR ENTRY key
to un-assign any assigned bits before you start.
c. Place the cursor on the period under the 15 in the bit
assignment pop-up and press SELECT. This will place an
asterisk in the pop-up for bit 15, indicating Pod
1
bit l5 is now
assigned to the DATA label. Repeat this procedure until all
16
bits have an asterisk under each bit number. Place the cursor
on
Done and press
SELECT
to close the pop-up.
d. Repeat step c for Pod 2 and the ADDS label to assign all
16
b ts i .
e. Repeat step c except you will assign the lower eight bits (0 - 7)
of Pod 3 to the ADDR label.
State Analyzer Measurement Example
15-8
HP
16528/l 6538
Front-Panel Reference