HP 1652B Getting Started Manual page 411

Waveforms Menu
25-2
The Auto-measure field is located in the upper right comer of the
Waveforms menu. When the Auto-measure field is selected, a pop-up
will appear that lists the parameters measured for the channel selected.
' See Figure 25-2.
Figure
25-2.
Automatic Measurement Pop-up
The channel field , which is located in the upper right corner of the
pop-up, will toggle between channel
1
and channel 2 when selected.
The default selection for this field is channel 1.
There are nine automatic measurements made from the data that is
displayed in the waveform display:
Period
Risetime
Falltime
Frequency
+ Width
-Width
VP-lJ
Preshoot
Overshoot
Keep the following in mind when making measurements.
l
At least one full cycle of the waveform with at least two like edges
must be displayed for Period and Freq measurements.
HP 16528/1653B
Front-Panel Reference