HP 1652B Getting Started Manual page 707

Hide thumbs Also See for 1652B:

Table of Contents

9. Remove the six screws securing the oscilloscope assembly to the support

Do not remove the two screws at the front of the oscilloscope board that hold the

two attenuators in place.

Remove the two nuts

and two washers (H20) that secure the

attenuator BNCs to the front panel.

Slide the oscilloscope assembly toward the rear panel to allow the BNCs to

clear the front panel.

Remove the oscilloscope assembly by tilting the rear of the assembly up and

lifting the assembly out through the top of the instrument cabinet. Make sure

that the BNCs clear the front panel.

Replace the oscilloscope assembly by reversing this procedure.

When you reinstall the top cover, insert the four screws on the sides of the cover

first while making sure the cover fits into the grooves of the instrument cabinet.

Then insert the six screws in the top of the cover.

COMPENSATION

and Replacement

Figure 6D-3. Oscilloscope

Service Manual

Chapters

Table of Contents