Connecting The Equipment; Setting Up The Oscilloscope - HP 1652B Getting Started Manual

Hide thumbs Also See for 1652B:

Table of Contents

Set up the oscilloscope as described below. This instrument setup will

Selection Setup

be used throughout the remainder of this example.

Connecting the Equipment

Connect a BNC tee adapter and BNC cables to the oscilloscope as

shown below.

Compensation Signal Hookup

Setting Up the Oscilloscope

1. Turn the power on to the instrument.

2. From the System Configuration menu, turn the oscilloscope on

HP 16528/1653B

Front-Panel Reference

and all analyzers off.

Touch CHAN key. From the default oscilloscope Channel menu,

make the following changes:

CH 1 Probe field to 1:l

CH 1 Impedance field to 50 Ohms

CH 2 Probe field to 1:l

CH 2 Impedance field to 50 Ohms

Select Autoscale and set to Continue.

Touch the TRIG key to display the Trigger menu.

Channel Menu

Chapters

Table of Contents