Acquisitionmode - HP 1652B Getting Started Manual

--
Trace Mode
With the Trace mode field you specify the mode in which the timing
analyzer will trace. You have two choices for Trace mode: Single and
Repetitive. If you place the cursor on the field and press SELECT, the
field toggles from one mode to the other.
Single Trace mode acquires data once per trace. Repetitive Trace
mode repeats single acquisitions until the STOP key on the front panel
is pressed, or if Stop measurement has been selected and the stop
measurement condition has been met.
If both analyzers are on, only one Trace mode can be specified.
Specifying one trace mode for one analyzer sets the same trace mode
for the other analyzer.
Armed By
The Armed by field lets you specify how your timing analyzer is to be
armed. The analyzer can be armed by the RUN key, the other analyzer,
the scope or an external instrument through the BNC Input port.
When you select the Armed by field, a pop-up menu appears like that
shown below. Use this menu to select the arming option for your
analyzer.
Armed by
Figurel8-2. Armed By Pop-Up Menu
Acquisition Mode
The Acquisition mode field allows you to specify the mode in which
you want the timing analyzer to acquire data. You are given two
choices for the mode of acquisition: Transitional and Glitch . If you
place the cursor on this field and press SELECT, the field toggles from
one mode to the other.
HP 16528/1653B
Front-Panel Reference
Timing Trace Specification Menu
18-3