Re-Acquiring The Data; Mixed Mode Display - HP 1652B Getting Started Manual

Re-Acquiring
the Data
With the timing analyzer configured and the probes of pod 5 connected
to the circuit, all you have to do is press RUN. When the logic analyzer
acquires the data it switches the display automatically to the Timing
Waveforms menu, unless you switched to one of the other menus in the
state analyzer after reconfiguring the Timing Trace menu. In that case,
you will be in the State Listing menu. Regardless of which analyzer
display menu you are in, you should now look at both analyzers
together in the Mixed Mode Display.
Mixed Mode
Display
The Mixed mode display shows you both the State Listing and Timing
Waveforms menus simultaneously. To change the display to the Mixed
Mode:
1. Select the field in the upper left corner of the displav and press the
4
SELECT key.
2. Select the Mixed mode field. You will now see the Mixed Mode
display as shown below.
HP 16528/1653B
Front-Panel Reference
Lflixed Rode]- Display
INXI
- Ststc
Listing
I
+ooo 1
055 I
DECR tIEtlORY READ 3.00 us
w +0002 0552
OUT TO P IlEtIORY HR ITE 2.00 us
I
fxGi]
+ooo
+0005
3
0554
0553 0555
HOVE DECR
DECR
IlEflORY fiEtlORY
IlEflORY READ
REFlD HRITE 2.00 I .52
2.00 us
us us
0557 OUT TO P
0556
CALL
I'lEflORY READ
I'lEflORY WRITE
I .48 us
2.00 us
- Tlmng Navofoms
Tlme/Dlv [ml Delay 71 0 to Trigger [11.60]
Figure 2740. Mixed Mode Display
Timing/State/Scope Measurement Example
27-13