Mixed Mode Display With Scope - HP 1652B Getting Started Manual

Mixed Mode
With three different measurements stored in memory, you can now get
Display with
Scope
the total picture of your problem from the Mixed Mode display. As
mentioned before, the scope must be armed by the timing analyzer and
set to trigger Immediate before the time-correlated scope signals can
be inserted into the Timing Waveforms display
Insert the scope waveforms into the Timing Waveforms display
(the lower display in Mixed Mode) as shown below.
-~ ~~
Itllxed flode]- Display INIT - State Listing
I
LObe 1
Base i m-M-/
+ooo 1 055 1 DECR
tlEtlORV READ 3.00 us
I
x MOO2 0552
OUT TO P tlEtiORV WRITE 2.00 us
+ooo 3
0553
tlOVE tlEflORV READ 1 .s2 us
ptzz\ 0554 DECR tlEtlORV READ
2.00 us
+0005 0555 DECR IlEtlOR'r WRITE 2.00 us
o +0006 0557 OUT TO P
tlEtlORV RECID I .48 us
+0007 0556 CALL
UEflORk WRITE 2.00 us
PORTS
- Timing
Heveforrs X to Trigger
5.000 UC
Tlme/Dlv
[ 10.00 us ] Delay
[ 0 s ] 0 to Trigger
11.60 us
,
Insert scope signals here
Figure 27-14. Mixed Mode Display
1. Select the upper-left most field and press the SELECT key.
2. From the pop-up select the Mixed Mode field.
3. From the Mixed Mode display menu, select the LOUTPT field
and insert the scope's CH
1
waveform. The waveform should
appear directly below LOUTPT.
4. Select the LDISP field and insert the scope's CH 2 waveform. The
waveform should appear directly below LDISP.
Timing/State/Scope Measurement Example
27-18
HP 16528/1653B
Front-Panel Reference