State/Timing And Scope Mixed Mode Display - HP 1652B Getting Started Manual

State/Timing
And Scope
Mixed Mode
Display
When the state analyzer, timing analyzer and the oscilloscope are all
on, you can display both analyzer waveforms and the oscilloscope
waveforms simultaneously as shown below.
State display
Scope display
0
Timing display
Mixed Mode Displays
26-8
INIT - State Llbtlng
0553 OUT TO P UEnORY HRITE
1.52 us
0554 IIOVE
I-lEtlORY RE6D 2.00 us
0555
DECR tlEHORY READ 2.00 us
0557 OUT TTJ P
UEtlORY HRITE 1,46 us
0558 tlOVE IlEflORY READ 2.00 us
+oooEl
woo9
0559 DECR
054 1 DECR
tlEtiORY READ
rlEtiOf?Y REF\D
1.52 us
PORTS
- Tinmg llaveforms
Tlme/Div I] Delay
X to Trigger
0 5
0 to Trigger
0 s*
Figure 26-9. State/Timing/Scope Mixed Mode Display
The arming requirements for the oscilloscope are the same as in
timing/scope mixed mode displays.
The procedure for inserting waveforms in the timing waveforms display
is the same as in timing/scope mixed mode displays.
The markers for the state analvzer, timing analyzer and oscilloscope in
time-correlated Mixed Mode are different from the markers in the
individual waveforms and listing displays. You will need to place the
markers on your points of interest in the time-correlated Mixed Mode
even though you have placed them in the individual displays
HP 1652B/53B
Front-Panel Reference