HP 1652B Getting Started Manual page 498

Logic
Hide thumbs Also See for 1652B:
Table of Contents

Advertisement

Waiting for Trigger. Indicates the trigger condition has not occurred.
Warning: Chips not successfully running. Indicates the acquisition
chips in the logic analyzer are not running properly. Press STOP and
then RUN again. If the warning message reappears, refer the logic
analyzer to service personnel.
Warning: Chips not successfully stopped. Indicates the acquisition
chips in the logic analyzer are not stopping properly. Press RUN and
then STOP again. If the warning message reappears, refer the logic
analyzer to service personnel.
Warning: Duplicate label name.
existing name to a new label.
Indicates an attempt to
an
Warning: Duplicate symbol name. Indicates an attempt to assign an
existing name to a new symbol.
Warning: Invalid file type. Indicates an attempt to load an invalid file
type. For example, the SYSTEM file can only be loaded on power-up
and if you attempt to load it from the I/O menu, this message will
appear.
Warning: No clock edge in other clock, add clock edge. This message
only occurs in a state analyzer using mixed or demultiplexed clocks. It
indicates there is no edge specified in either the master or slave clock.
There must be at least one edge in each of the clocks.
Warning: Symbol memory full. Max 200 symbols. Indicates an attempt
to store more than 200 symbols.
Warning: Run HALTED due to variable change. Indicates a variable
has been changed during data acquisition in the continuous trace
mode. The data acquisition will be halted and this message will be
displayed when any variable affecting the system configuration, clock
thresholds, clock multiplexing, or trace specification menus is changed
during data acquisition.
-
HP 16528116538
Front-Panel Reference
Error Messages
C-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

1653b

Table of Contents