HP 1652B Getting Started Manual page 273

Hide thumbs Also See for 1652B:

Table of Contents

Since you want to capture the data when the microprocessor sends

address 0000 on the bus after power-up, you press the RUN key to arm

the state analyzer and then force a reset of your circuit. When the reset

cycle ends, the microprocessor should send address 0000 trigger the

state analyzer and switch the display to the State Listing menu.

From this point in the exercise unto the end, we will give you the

measurement results. This way, you will not have to obtain and use an

identical circuit.

Reset Vector Fetch Routine

State Analyzer Measurement Example

Reset Vector Fetch Routine

HP 16528/1653B

Chapters

Table of Contents