Option Installation; Installation; Option 004 Comparator Installation; Coupling Option 004 Comparator - HP 4262A Operating And Service Manual

Section II
Paragraphs 2-29 to 2-34
2-29. OPTION INSTALLATION.
2-30. When it is desired to add one or two of the
available optional features to a standard 4262A
instrument, perform the installation as follows:
Refer to option installation illustrations
on facing page.
a. Push LINE switch to off.
b. Remove instrument top cover.
INSTALLATION.
covers from the rear panel.
. Install two 50-pin connector assemblies in the
openings.
assembly (RED/ORANGE GUIDE, P/N:
04262-66523
or 04262-66623) from OFF to
opposite position. This board is located third
from front on the right side.
f. Install instrument top cover.
2-6
Model 4262A
2-32. OPTION 004 COMPARATOR
INSTALLATION.
Refer to Fig 2-4 for installation procedure.
2-33, COUPLING OPTION 004 COMPARATOR
WITH OPTION 001 BCD DATA OUTPUT
INSTALLATION.
a. Set CMP (comparator) and BCD option
switches of SW1 ON A23 board assemblies
(RED/ORANGE GUIDE, P/N: 04262-66523
or 0426266623)
from
OFF to opposite
position. This board is located third from
front on the right side.
.Connect cables attached to A23 board be-
tween A23 and A24 comparator option BCD
change is necessary for this combination of
options.
. Refer to Paragraphs 2-31 and 2-32 for other
installation procedures.
2-34. OPTION 101 HP-IB REMOTE CONTROL
AND DATA OUTPUT INSTALLATION.
panel.
. Install connector board assembly (P/N:
. Set the HP-IB switch of SW1 on A23 board
.Connect cable assembly attached to A25
board between A23 and A25 HP-IB option
board assemblies (P/N: 04262-66525). Install
A25 in RED/GREEN GUIDE option
receptacle.
. Plug flat cable assembly from connector
board assembly P/N: 04262-66503 into A25
board assembly (installed in RED/GREEN
GUIDE receptacle).
.
OPTION 101 IS NOT COMPATIBLE
WITH OPTIONS 001 AND 004.