Usb/Memory Stick; Other Control Panel Connections - Sony MVS -8000X Quick Setup Manual

the control panel installation manual for a complete description of the MKS-8075A adapter and its
mounting options (they can be daisy-chained, connected together, stacked horizontally or vertically,
etc). You will notice in the MKS-8075A box there is a small 6-inch SWC cable. This cable is for daisy-
chaining the external adapters together (when two or more are purchased) and is not for connecting to
the SCU. Please be sure to save that cable as they are quite expensive to replace if you find you need
one later.
Whether you are daisy-chaining them or not, the first MKS-8075A adapter needs to be connected to the
SCU. If you purchased the 8075A, you would have automatically purchased an additional SWC cable.
This cable may be 5 or 10 meters. Connect one end to the SCU port marked "EXT PANEL2" (if you have
an integrated Aux and did not hook anything up to the EXT PANEL1 connector you may use that instead),
then connect the other end to the 8075A adapter. Please note that each side has a connector, each
with a unique gender. The opposite gender is used to daisy-chain to another 8075A.
Follow the installation manual instructions for placing the module you want mounted externally into the
8075A. MAKE SURE THE SCU POWER IS OFF WHILE MOUNTING THE MODULE.
Be sure to tighten all the SWC cables before applying power to the SCU, as having a cable detach while
power is applied can also result in a blown fuse.

USB/Memory Stick

We need to connect the supplied USB cable to the SCU. Please connect the Type A (flat) end of the
supplied USB cable to the DEVICE port on the SCU. If you have a USB/Memory Stick Module, the Type-B
end (square) needs to be plugged into the back of the panel where the USB Module is located. For
instance, if the USB module is in the separate aux row on a 4 M/E or 3 M/E panel, you would connect
the Type-B plug near where you already connected the SWC cable for the aux row. If the USB module is
in the main (large) section of the panel, then connect the Type-B plug near the SWC cable for the main
panel. It is also possible that your USB module is outside the panel in a MKS-8076 adapter. The MKS-
8076 adapter looks almost identical to the MKS-8075A adapter, described above, except the MKS-8076
adapter is used exclusively for the USB module and has only a USB Type-B connector instead of the 50-
pin connector of the MKS-8075A.
If you do not have a USB module, then it is likely you will use a USB hub of your own. Please connect the
Type-B plug to your self-powered USB hub.

Other Control Panel connections

The SCU also requires house "black" reference. If you are not looping reference, please terminate with a
75-ohm terminating resistor.
The network cables should all be connected as described above in the LAN section. If they have not yet
been connected to all chassis, please refer above to the LAN section and wire the LANs before
continuing.
The Timecode BNC connector is only used when the Plug-in Editor option is purchased with the
switcher. If you have purchased this option, connect house timecode (unbalanced BNC audio) to this
connector.
pg. 28