Setting Signal Formats; Setting The Signal Format - Sony MVS-3000A System Startup Manual

Setting Signal Formats

Setting the Signal Format

You can set the signal format and the input reference signal
format of each device that is automatically detected.
The combinations of signal formats and input reference
signals that can be configured are as follows.
Signal format
System Signal format
Field frequency
SD system 50
59.94
HD system 50
59.94
50
59.94
23.976
24
Input reference signal
Signal format Input reference signal
(HD system)
Tri Sync BB
720P/50 –
720P/59.94 59.94
1080i/50 50
1080i/59.94 59.94
1080PsF/23.976 47.952
1080PsF/24 48
1
Display the menu.
a Open the Engineering Setup >System >Format
menu (7313).
Effective number
of scan lines
576i
480i
720P
1080i
1080PsF
Black Burst 50 Sync 50
Black Burst 59.94 Sync 59.94
Black Burst 50 Sync 50
Black Burst 59.94 Sync 59.94
–
–
2
Set the formats.
Ref Input Format
Signal Format
MVS-6520/6530/3000A screen shown.
On the MVS-3000, [DME1] is not displayed.
Format menu
a Press [Signal Format].
b Press the button for the desired format to set in the
pop-up window.
3
Set the input reference signal.
a In the <Ref Input Format> group, select the input
reference signal.
Tri Sync: Tri-level sync for an HD system
BB: Black burst or sync
Notes
This setting is available for HD systems only.
Memo
If [BB] is selected, you can set the signal format
conversion in the format converter (when MKS-6550
Format Converter Board is installed). If [Tri Sync] is
selected, the format converter cannot be used.
For details about format converter settings and
operations, refer to the User's Guide.
Execute
21
Setting Signal Formats