Printing The Self-Diagnosis Report - Ricoh G147 Service Manual

No. Name
1 Web Support
2 Network Support
3 Onboard Sys
4 Onboard Prn
5 Engine
6 NetworkDocBox
The "Engine" module is very large and very slow to start. You may not see the
asterisks (*) display until about 60 sec. have elapsed. (Total time: approximately 7
min. to complete.)

5.8.4 PRINTING THE SELF-DIAGNOSIS REPORT

The Self-Diagnosis Report, printed with SP5990 (SP Print Mode), lists the current names
and version numbers of the update modules.
1. To enter the SP mode, push and hold down
2. Push to display "2. Engine" then push [#Enter].
3. Push to display "5. Mode" then push [#Enter].
SP5024
mm/inch Display
4. Push once to select SP5990 then push [#Enter].
SP5990-001
All (Data List)
5. Push three times to select SP5990-005 then push [#Enter].
<Diagnostic Repo
execute?
6. Push [#Enter] to print the report.
The firmware module names and version numbers are listed in the report.
SM
Time
20 sec.
40 sec.
90 sec.
50 sec.
7 min.
10 sec.
for 5 sec. then push [#Enter].
5-113 G147