Leaving The Sp Mode - Ricoh G147 Service Manual

To change a single-digit number setting:
Press [#Enter]. A number replaces the cursor.
Press or to increase or decrease the number.
Press [#Enter]. The number selected on the 2nd line replaces the number above.
Press to return to the previous level.
To change a multiple-digit number setting
Press or to move the cursor to the digit that you want to change.
Press [#Enter]. A number replaces the cursor.
Press or to increase or decrease the number.
Press [#Enter]. The number selected on the 2nd line replaces the number above.
Repeat the procedure to enter numbers for the other digits.
Press #(Escape) to return to the previous level.
To select an item from a list
The current selection is marked with a large asterisk ().
Press or to display on the 2nd line the item to select.
With the item that you want to select displayed on the second line, press [#Enter].
The selected item is marked with an asterisk.
Press [Escape] to return to the previous level.

5.1.5 LEAVING THE SP MODE

1. When you are finished with SP selection, press [Escape] until you see "2.Engine".
2. Press to display "3.End".
3. Press [#Enter] to display "Offline".
4. Press [Online] to set the printer online.
Powering the printer off and on leaves the SP mode, and returns the printer
online in normal operation mode.
SM 5-5 G147