Installing Controller Options - Ricoh G147 Service Manual

13. Confirm that the SD card applications have been enabled:
Push [Menu] then select "List/Test Print"> "Config. Page" to print the configuration
page.
14. Turn the machine off again, then:
Attach the SD card slot cover.
Tape the copied source card to the faceplate of the controller box.
Attach the rear cover of the machine.
After an SD card is copied, it cannot be used. But it must be stored at the customer
site, to serve as proof of purchase by the customer.
The original card can also be used to perform an undo procedure (SP 5873 002).
Before you tape the copied SD card to the machine, label it carefully so that you can
identify it easily if you need to do the undo procedure at a later time (see 'Undo
Exec').
Undo Merging
1. Turn the main switch off.
2. Put the SD card with the merged applications in C1.
3. Insert the original destination SD card (the one taped to the faceplate of the
controller box) into C3.
The SD card in C3 must be the original SD card of the application you want to
move from C1 to C3. You cannot use any blank SD card in C3.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-002 (Undo Exec)
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the SD cards from the slots.
9. Turn the main switch on.

1.9.4 INSTALLING CONTROLLER OPTIONS

256 MB Memory (G818) or 128 MB Memory (B584)
- Accessories -
Check the accessories and their quantities against the following list:
G147 1-28 SM