Ricoh G147 Service Manual page 239

090 TELNET
091 Web
145 ActIPv6LinkLocal
147 ActIPv6Sttles1
149 ActIPv6Sttles2
151 ActIPv6Sttles3
153 ActIPv6Sttles4
155 ActIPv6Sttles5
156 IPv6 Manual Address
SM
or dispabled for each protocol. This is a 8-bit setting.
0 LPR 4
1 FTP (Not Used) 5
2 IPP 6
3 SMB 7
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
This is the IPv6 local address referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each. These
notations can be abbreviated. See "Note: IPV6
Addresses " below this table.
These SPs are the IPv6 stateless addresses (1 to 5)
referenced on the Ethernet or wireless LAN (802.11b)
in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
This SP is the IPv6 manually set address referenced
on the Ethernet or wireless LAN (802.11b) in the
format:
5-49
BMLinks (Japan Only)
DIPRINT
Reserved (Not Used)
Reserved (Not Used)
G147