Ricoh G147 Service Manual page 180

Display
(-10) Internal kernel error
(-11) Size of drive is too small
(-12) Specified partition does not exist
(-13) Device file does not exist
- Recovery from SC 925 -
Procedure 1
If the machine shows SC codes for HDD errors (SC860 ~ SC865) with SC 925, do the
recovery procedures for SC860 ~ SC865.
Procedure 2
If the machine does not show one of the five HDD errors (SC860 ~ SC865), turn the
machine power off and on. If this is not the solution for the problem, then initialize the NetFile
partition on the HDD with SP5832-011 (HDD Formatting – Ridoc I/F).
NetFiles: Jobs printed from the document server using a PC and DeskTopBinder
Before you initialize the NetFile partition on the HDD, tell the customer that:
Received faxes on the delivery server will be erased
All captured documents will be erased
DeskTopBinder/Print Job Manager/Desk Top Editor job history will be erased
Documents on the document server, and scanned documents, will not be erased.
The first time that the network gets access to the machine, the management information
must be configured again (this will use a lot of time).
Procedure 3
If "Procedure 2" is not the solution for the problem, do SP5832-001 (HDD Formatting – All),
then turn the machine power off and on.
SP5832-001 erases all document and address book data on the hard disks. Ask the
customer before you do this SP code.
Procedure 4
If "Procedure 3" is not the solution for the problem, replace the HDD.
F-gate assert error at write request
951 D
After the IPU receives an F-gate signal, it
receives another F-gate signal.
G147
Meaning
4-30
Software defective
BICU defective
SM