Ricoh G147 Service Manual page 208

Displays the GAIN value used to calculate the on time for the toner supply motor.
Image Pixel Cnt
005
Displays the image pixel count.
Trans Curr Adj
2301
Adjusts the current applied to the transfer belt during printing the 5 phases listed
below.
Image Face
Printing the first side of the paper (image area).
001
If the user uses thicker paper, the current may have to be increased to ensure
sufficient transfer of toner.
[20 ~ 100 μA / 45 / 1 μA step]
Image Back
002
Printing the second side of the paper (image area) during duplex printing.
[20 ~ 100 μA / 40 / 1 μA step]
Lead Edge Face
Printing at leading edge of the paper.
003
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
[20 ~ 100 μA / 45 / 1 μA step]
Img Face Bypass
004 Printing from the by-pass tray (image area).
If the user normally feeds thicker paper from the bypass tray, use a higher setting.
[20 ~ 100 μA / 45 / 1 μA step]
Lead Face Bypass
005 Printing at the leading edge of paper fed from the by-pass tray.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
G147
Image Pixel Count
Transfer Current Adjustment
1st Side of Paper
2nd Side of Paper
Leading Edge. Face
Image Face By-pass (By-pass Feed)
Leading Edge By-pass Feed
5-18 SM