Service Program Mode Operation; General Notes; Entering And Leaving The Service Program Mode - Ricoh G147 Service Manual

5. SERVICE TABLES

5.1 SERVICE PROGRAM MODE OPERATION

5.1.1 GENERAL NOTES

The service program (SP) mode is used to check electrical data, change modes, and adjust
values.
Never turn off the power switch when the power LED is lit or flashing.
The power LED lights or flashes while the machine is communicating with the
network server, or while the machine is accessing the hard disk or memory
5.1.2 ENTERING AND LEAVING THE SERVICE PROGRAM
MODE
1. To set the printer in the service mode:
If the printer is off, press and hold down [Online] and [Escape] then switch the printer on.
Release the buttons when you see "1. Service" in the LCD.
-or-
If the printer is on, press and hold down
Press[#Enter]. You will see "1. Service" in the LCD. The printer is in the service mode.
2. Press or to display the menu titles.
SM
and for over 5 seconds and release.
5-1 G147