Ricoh G147 Service Manual page 142

2. Remove the SD card cover [A].
3. Plug the SD card [B] into SD card slot C3..
4. Turn on the main switch.
5. To enter the SP mode, press
[#Enter].
6. Select SP5824.
SP5825
NVRAMDownload
7. Push [#Enter].
8. When the message prompts you to execute, push [#Enter].
<NVRAMDownload>
Processing
<NVRAMDownload>
result = OK
9. Remove the SD card.
10. Switch the machine off and on.
If the SD card is not installed properly, a message will tell you that downloading
cannot proceed.
If the correct SD card for the NVRAM data is not inserted in the SD card slot, after
you press [#Enter] a message will tell you that downloading cannot proceed.
G147
together (5 seconds), release, then press
3-66 SM