Ricoh G147 Service Manual page 197

002 Tray-2
003 Tray-3
004 Tray-4
005 Duplex Tray
006 Bypass Tray
007 LCT
Regis Buckle Adj
1003
Adjusts the relay clutch timing at registration. Relay clutch timing determines the
amount of paper buckle at registration. (A "+" setting causes more buckling.)
001 Trays 2,3,4, LCT
002 Duplex Tray
003 Bypass Tray
004 Tray-1
005 By-pass Thick
By-pass SizeDisp DFU
Displays the paper width sensor data for the by-pass feed table. The detected
1007
paper size display is shown as bit settings in an 8-digit display.
(7)1110 0000(0)
Exit Jct. SOLs
Adjusts the timing of the solenoids at the entrance and exit of the paper exit
section to accommodate the increased speed of the duplex unit.
1012
This SP has been added to compensate for the increased operation speed of the
duplex unit for this machine. Increase the value if the leading edges are jamming.
Decrease the value if trailing edges are bending at the entrance
SM
[–9 ~ +9/ +3.0 mm / 0.1 mm step]
[–9~ +9/ +2.0 mm / 0.1 mm/step]
[–9~ +9/ +2.0 mm / 0.1 mm/step]
[–9 ~ +9/ +0.0 mm / 0.1 mm/step]
[–9 ~ +9/ +3.0 mm / 0.1 mm/step]
[–9 ~ +9/ +1.5 mm / 0.1 mm/step]
Registration Buckle Adjustment
[–9 ~+9 / 0 /1 mm step]
[–9 ~+9 / 1 /1 mm step]
[–9 ~+9 / -2 /1 mm step]
By-pass Feed Paper Size Display
Exit Junction Solenoid Start Timing
5-7 G147