Siemens bt300 Operator's Manual page 142

Chapter 4 - Parameters and Menu Structure
I/O and Hardware (M5)
Register number
0001 - 2000 Siemens Application IDs
2001 - 2050 FBProcessDataIN
2051 - 2099 FBProcessDataIN
2101 - 2150 FBProcessDataOUT
2151 - 2199 FBProcessDataOUT
2200 - 10000 Siemens Application IDs
10501 - 10530 IDMap
10601 - 10630 IDMap Read/Write
10701 - 10760 IDMap Read/Write
20001 -40000 Siemens Application IDs
40001 - 40007 Operation day counter
40101 -40107 Resettable operation day counter
40201 - 40203 Energy counter
40301 -40303 Resettable energy counter
40401 - 40430 Fault history
Application IDs
Application IDs are parameters that depend on the frequency converter's application. These parameters can be
read and written by pointing the corresponding memory range directly or by using the so-called ID map. It is
easiest to use a straight address if you want to read a single parameter value or parameters with consecutive ID
numbers. It is possible to read 12 consecutive ID addresses.
FB Process data IN
The process data fields are used to control the drive (for example, Run, Stop, Reference, Fault Reset) and to
quickly read actual values (for example, Output frequency, Output current, Fault code). The fields are structured as
follows:
Process Data Master → Slave (max 22 bytes)
Address
16-bit* 32-bit
2001
2002
142 | 180
Siemens Industry, Inc.
Building Technologies
Table 112: Defined Modbus Input and Holding Registers.
Purpose
Table 113: Modbus Parameter IDs.
Register number
0001-2000 Application parameters
2200-10000 Application parameters
Table 114: Fieldbus Process Data IN.
Name
2051 = High data FB Control Word
2052 = Low data
- Reserved
Siemens BT300 HVAC Drive
Access type
16-bit Parameter IDs [➙ 142]
16-bit Fieldbus Process Data IN [➙ 142]
32-bit Fieldbus Process Data IN [➙ 142]
16-bit Fieldbus Process Data Out [➙ 143]
32-bit Fieldbus Process Data Out [➙ 143]
16-bit Parameter IDs [➙ 142]
16-bit ID Map Initialization [➙ 145]
16-bit Parameter Values in 16-bit IDMap
Read/Write Registers [➙ 145]
32-bit Example of Parameter Values in 32-bit
IDMap Read/Write Registers [➙ 146]
32-bit Parameter IDs [➙ 142]
16-bit Operation Day Counter [➙ 146]
16--bit Resettable Operation Day Counter [➙ 146]
16bit Energy Counter [➙ 147]
16-bit Resettable Energy Counter [➙ 147]
16-bit Fault History [➙ 147]
Purpose Application ID
1 through 2000
2200 through
10000
Binary coded
Binary coded
See the Table...
Range/Type
DPD01809
2016-06-07