Siemens bt300 Operator's Manual page 62

Chapter 4 - Parameters and Menu Structure
Parameters (M3)
Selection Selection name
24 Reserved
25 PID1 supervision limits
26 PID2 supervision limits
27 Motor 1 control
28 Motor 2 control
29 Motor 3 control
30 Motor 4 control
31 Reserved
32 Reserved
33 Reserved
34 Maintenance warning
35 Maintenance fault
36 Thermistor fault
37 Motor switch
38 Bypass active
39 Bypass running
40 Drive active
41 Drive output contactor
42 Overload Fault
43 Essential Services active
44 Auto Bypass active
45 Interlock Proofing
46 Interlock Proofed
47 Stop Forced
48 Remote Start
Slot C (M3.5.3.3)
If an expansion I/O board that contains a digital/relay output exists in slot C, then this section will be populated with
parameters to represent that I/O.
62 | 180
Siemens Industry, Inc.
Building Technologies
PID1 feedback value is beyond supervision limits.
PID2 feedback value is beyond supervision limits.
Multi-pump
Contactor control for
Multi-pump
Contactor control for
Multi-pump
Contactor control for
Contactor control for Multi-pump
(Always open.)
(Always open.)
(Always open.)
Selects relay output for the Bypass active signal. This signal is on when
the drive is in Bypass mode.
Selects relay output terminal for Bypass contactor control.
Selects relay output for the Drive active signal. This signal is on when
the drive is in Drive mode.
Controls the Drives Output contactor.
Selects relay output for the Overload fault signal. This signal is on when
the Overload fault is active.
Selects relay output for the Essential services signal.
Selects relay output for the Auto Bypass active signal
Selects relay output for the Interlock Proofing signal.
Selects relay output for the Interlock Proofed signal.
Selects relay output for the Local Stop Forced from keypad signal.
Selects relay output for the Remote Start signal
Siemens BT300 HVAC Drive
Description
function.
function.
function.
function.
DPD01809
2016-06-07