Sine Filter (M5.6.4); Keypad (M5.7) - Siemens bt300 Operator's Manual

Structure Parameter
P5.6.1.1 Fan Control Mode
M5.6.1.5 Fan Lifetime
P5.6.1.6 Fan Lifetime Alarm
Lim.
P5.6.1.7 Fan Lifetime Reset

Sine Filter (M5.6.4)

Sine filter support restricts overmodulation depth and prevents thermal management functions from decreasing
switching frequency.
Structure Parameter
P5.6.4.1 Sine Filter

Keypad (M5.7)

Configuration of the keypad-specific items such as contrast, backlight time, and the default screen are completed
in this section.
In Firmware FW0183V011 and earlier, the display does not default to any particular place. Whatever was last
entered on the screen will remain there until changed. However, in FW0183V012 and later, the screen defaults to
the Multimonitor display after two minutes of inactivity of the keypad. If you prefer a different default screen, use
the parameters in this section to make those changes.
Siemens Industry, Inc.
Building Technologies
Table 84: Cooling Fan Settings.
Unit Min
Always On Optimized
h
h 0 200000
Table 85: Sine Filter Settings.
Unit Min
Disabled Enabled
Siemens BT300 HVAC Drive
Chapter 4 - Parameters and Menu Structure
Max Default ID
1 2377
849
50000 824
823
Max Default ID
Disabled 2527
I/O and Hardware (M5)
Description
Defines the heat sink cooling fan
mode:
0 = Always On
1 = Optimized
Displays the cooling fan's run time
in hours.
NOTE: Fan Lifetime Reset
(P5.6.1.7) will reset this value.
Defines the alarm limit for the
cooling fan's useful life.
Reset parameter for the Fan
Lifetime (M5.6.1.5)
Description
Enable parameter for the Sine
Filter.
115 | 180
DPD01809
2016-06-07