Siemens bt300 Operator's Manual page 61

Structure Parameter
P3.5.3.2.4 RO2 Function
P3.5.3.2.5 RO2 ON Delay
P3.5.3.2.6 RO2 OFF Delay
P3.5.3.2.7 RO3 Function
Basic RO functions
Selection Selection name
0 Not used
1 Ready
2 Run
3 General fault
4 General fault inverted
5 General alarm
6 Reversed
7 At speed
8 Motor regulator activated
9 Preset frequency active
10 Keypad control active
11 I/O control B active
12 Limit supervision 1
13 Limit supervision 2
14 Start command active
15 Reserved
16 Fire mode ON
17 RTC timer 1 control
18 RTC timer 2 control
19 RTC timer 3 control
20 FB Control WordB.13
21 FB Control WordB.14
22 FB Control WordB.15
23 PID1 in Sleep mode
Siemens Industry, Inc.
Building Technologies
Unit Min
None Remote Start General
s 0 320
s 0 320
None Remote Start Ready
Table 34: Basic RO Functions.
The variable frequency drive is ready to operate.
The variable frequency drive operates (motor is running).
A fault trip has occurred.
A fault trip has
The reverse command has been selected.
The output frequency has reached the set reference.
One of the limit regulators (for example, current limit or torque limit) is
activated.
The preset frequency has been selected with digital input.
Keypad control mode selected.
I/O control place B selected.
Activates if the signal value falls below or exceeds the set supervision
limit (P3.8.3 or P3.8.7) depending on the selected function.
Start command is active.
Time channel 1 is used.
Time channel 2 is used.
Time channel 3 is used.
Siemens BT300 HVAC Drive
Chapter 4 - Parameters and Menu Structure
Max Default ID
11004
Fault
0 11005
0 11006
11007
Description
not occurred.
Parameters (M3)
Description
Basic RO Functions Table
See
Defines the amount of time that will
pass before the relay output will
energize (ON) after trigger of the
RO2 Function (P3.5.3.2.4).
Defines the amount of time that will
pass before the relay output will de-
energize (OFF) after trigger of the
RO2 Function (P3.5.3.2.4).
Basic RO Functions Table
See
DPD01809
2016-06-07
.
.
61 | 180