Parameter Compare (M6.6); Favorites (M7); User Levels (M8) - Siemens bt300 Operator's Manual

Structure Parameter
P6.5.1 Restore Factory
Default
P6.5.2 Save to Keypad
P6.5.3 Restore from Keypad
P6.5.4 Save to Set 1
P6.5.5 Restore from Set 1
P6.5.6 Save to Set 2
P6.5.7 Restore from Set 2

Parameter Compare (M6.6)

The keypad can be used to compare the drive's active set of parameters to default values, stored sets on the drive,
and the stored set on the keypad. See the
restore using these sets.
Structure Parameter
P6.6.1 Active Set-Set 1
P6.6.2 Active Set-Set 2
P6.6.3 Active Set-Defaults
P6.6.4 Active Set-Keypad Se

Favorites (M7)

Favorites are typically used to collect a set of commonly referred to sets of parameters or monitoring signals from
any of the keypad menus. Items can be added to the Favorites folder by selecting the Add To Favorites option.
To remove an item from the Favorites menu, select the item in the Favorites menu, and then select the Rem from
Favorites option.

User Levels (M8)

User level parameters are intended to restrict the visibility of parameters and prevent the unauthorized and
inadvertent parameterization on the keypad.
To lock the keypad from unauthorized changes, complete the following steps:
1. Set Access Code (P8.2) to a value other than 0.
Siemens Industry, Inc.
Building Technologies
Table 135: Parameter Backup.
ID
831 Activation parameter for restoring parameters to the factory settings.
NOTE: Does not reset: Time (P5.5.2), Date (P5.5.3), Year (P5.5.4), Daylight Saving (P5.5.5)
2487 Initiates a copy of the active set of parameters to the keypad's storage location.
2488 Initiates a copy of the keypad's storage location to the active set of parameters.
2489 Initiates a copy of the active set of parameters to the drives set 1 storage location.
2490 Initiates a copy of the drives set 1 storage location to the active set of parameters.
2491 Initiates a copy of the active set of parameters to the drives set 2 storage location.
2492 Initiates a copy of the drives set 2 storage location to the active set of parameters.
Parameter Backup (6.5)
Table 136: Parameter Compare (M6.6).
ID
2493 Initiates a compare of the drive's active parameter set to the saved set 1. All
parameters that are different are displayed, with values.
2494 Initiates a compare of the drive's active parameter set to the saved set 2. All
parameters that are different are displayed, with values.
2495 Initiates a compare of the drive's active parameter set to the default values. All
parameters that are different are displayed, with values.
2496 Initiates a compare of the drive's active parameter set to the keypad saved set. All
parameters that are different are displayed, with values.
NOTE:
Store this access code in a safe place. If the code is lost, the only method to recover
is to reload firmware and re-commission the drive.
Siemens BT300 HVAC Drive
Chapter 4 - Parameters and Menu Structure
Description
section for details on how to back up and
Description
Favorites (M7)
163 | 180
DPD01809
2016-06-07