Basic (M2.2) - Siemens bt300 Operator's Manual

through the list of items until the desired value to be monitored is highlighted. Items with a checkmark are already
actively displayed in the multimonitor display. With an item chosen, press the
display field.

Basic (M2.2)

The basic monitoring values are the actual values of selected parameters and signals as well as statuses and
measurements. Different applications may have different statuses and different numbers of monitoring values.
NOTE:
Only Standard I/O board statuses are available in the Monitor menu. Statuses for all
I/O board signals can be found as raw data in the I/O and Hardware (M5) menu.
The basic monitoring values are presented in the following table:
Structure Parameter
M2.2.1 Output Frequency
M2.2.2 FreqReference
M2.2.3 Motor Speed
M2.2.4 Motor Current
M2.2.5 Motor Torque
M2.2.7 Motor Power
M2.2.8 Motor Power
M2.2.9 Motor Voltage
M2.2.10 DC-Link Voltage
M2.2.11 Unit Temperature
M2.2.12 MotorTemperature
M2.2.13 Analog Input 1
M2.2.14 Analog Input 2
M2.2.15 Analog Output 1
M2.2.16 Motor PreHeat
M2.2.17 DriveStatusWord
M2.2.18 Last ActiveFault
Siemens Industry, Inc.
Building Technologies
Table 6: Monitoring Menu Items.
Unit ID
Hz 1 Displays the actual output frequency.
Hz 25 Displays the actual frequency reference (setpoint).
rpm 2 Displays the actual motor speed.
A 3 Displays the actual motor current.
% 4 Displays the calculated motor torque.
% 5 Total power consumption of the drive in %
hp 73 Total power consumption of the drive in kW or hp
V 6 Voltage feed to the motor
V 7 Voltage available on the DC Link
ºF 8 Heat sink temperature
% 9 Calculated motor temperature
% 59 Signal of used range in %
% 60 Signal of used range in %
% 81 Signal of used range in %
1228 0 = Off
1 = Heating (feeding DC current)
43 Bit coded status of the drive
B1 = Ready
B2 = Run
B3 = Fault
B6 = Run Enable
B7 = Alarm Active
B10 = DC Current (in stop)
B11 = DC Brake Active
B12 = Run Request
B13 = Motor Regulator Active
37 Fault code of last activated fault that has not been reset.
Siemens BT300 HVAC Drive
Chapter 4 - Parameters and Menu Structure
Monitor Menu (M2)
button again to add to the
Description
See Fault Codes
.
31 | 180
DPD01809
2016-06-07