Application Settings (M3.17); Bypass (M3.18) - Siemens bt300 Operator's Manual

Chapter 4 - Parameters and Menu Structure
Parameters (M3)

Application Settings (M3.17)

The Applications Settings contain specific application information and are presented in the following table:
Structure Parameter
P3.17.1 Password
P3.17.2 kW/HP Selection
P3.17.3 °C/°F Selection
P3.17.4 ByPass

Bypass (M3.18)

The Bypass settings can only be accessed if Bypass (P3.17.4) is set to Electronic. The best way to set this is by
executing the Bypass Wizard (P1.21). The Bypass settings contain specific information about the Electronic
Bypass configuration.
The bypass settings are presented in the following table:
108 | 180
Siemens Industry, Inc.
Building Technologies
Table 72: Application Settings.Information.
Unit Min
0 65000
kW HP
ºC ºF
Disabled Electronic
Siemens BT300 HVAC Drive
Max Default ID
0
HP 1198
ºF 1197
Disabled 1809
Description
Location for entering a password to
the unit that will grant access to
development parameters.
Defines the selection of the unit's
power type parameters. Selectable
for kilowatt or horse power.
Defines the selection of the unit's
temperature type parameters.
Selectable for Celsius or
Fahrenheit.
Defines the bypass option
connected to the drive.
NOTE: To set the proper value for
this parameter, it is not
recommended to change this
parameter. This parameter is set
during the run of the Bypass Wizard
(P1.21)
Possible settings are as follows:
0 = Disabled
1 = Conventional
2 = Electronic
NOTE: The setting of Disabled
should also be used with all SED2
Migration Bypass Kits.
DPD01809
2016-06-07