Chapter 40: Serial Interface
High-Speed Serial Interface
This chapter outlines the configuration of module parameters (Layer 1) and, to a lesser degree,
the configuration of bundle parameters (Layer 2). The bundle configuration examples
demonstrate linking of physical interfaces (modules) to logical interfaces (bundles). Module
configuration occurs within the configure module tree of the Avaya CLI, and bundle
configuration occurs within the configure interface bundle tree.
Bundle Configuration
Configuration of an interface bundle is required for use of any of the Secure Router 3120 serial
interfaces. The interface bundle specifies the physical connection to be linked, an
encapsulation protocol (Layer 2) and, optionally, Layer 3 parameters.
Serial Configuration
DCE
Figure 44: V.35 DCE
and a Secure Router. In the figure, the router is configured for DTE operation and the Secure
Router V.35 is configured for DCE operation. Configuring the V.35 interface for DTE operation
is similar to the DCE configuration, though no clock speed is set in DTE mode.
Avaya Secure Router 1000 Series Configuration Guide
on page 260 shows a connection between a router with V.35 interface
December 2010
259