Clearing The Ip Address; Configuring The Ip Address To The Default Value; Displaying Ip Address Information - Avaya 3500 Quick Start Configuration

Configuring the switch using ACLI

Clearing the IP address

Use this procedure to clear the existing IP address and subnet mask for the switch or stack or
another unit of a stack.
Important:
When you change the IP address or subnet mask, you can lose connection to Telnet and the
Web. You also disable any new Telnet connection, and you must connect to the serial Console
port to configure a new IP address.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
no ip address [switch|stack|unit<1–8>]

Configuring the IP address to the default value

The default value for the switch is 192.168.1.1 for Standalone Mode or 192.168.1.2 for Stacking
Mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
default ip address

Displaying IP address information

Use this procedure to display IP configurations, switch address, subnet mask, and gateway address.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
September 2016 Quick Start Configuration
Comments on this document? infodev@avaya.com
42