The Firmware Management Screen - ZyXEL Communications USG40 User Manual

45.3.2 The Firmware Management Screen

Click Maintenance > File Manager > Firmware Management to open the Firmware
Management screen.
Figure 637 Maintenance > File Manager > Firmware Management
The following table describes the labels in this screen.
Table 382 Maintenance > File Manager > Firmware Management
LABEL
Firmware Status
Reboot
#
Status
Model
Chapter 45 File Manager
DESCRIPTION
Click the Reboot icon to restart the ZyWALL/USG. If you applied changes in the Web
configurator, these were saved automatically and do not change when you reboot. If you
made changes in the CLI, however, you have to use the write command to save the
configuration before you reboot. Otherwise, the changes are lost when you reboot.
If you want the Standby firmware to be the Running firmware, then select the Standby
firmware row and click Reboot. Wait a few minutes until the login screen appears. If the
login screen does not appear, clear your browser cache and refresh the screen or type the
IP address of the ZyWALL/USG in your Web browser again.
You can also use the CLI command reboot to restart the ZyWALL/USG.
This displays the system space (partition) index number where the firmwarm is located.
The firmware can be either Standby or Running; only one firmware can be running at
any one time.
This indicates whether the firmware is Running, or not running but already uploaded to
the ZyWALL/USG and is on Standby. It displays N/A if there is no firmware uploaded to
that system space.
This is the model name of the device which the firmware is running on.
ZyWALL/USG Series User's Guide
905