ZyXEL Communications USG40 User Manual page 369

Zywall/usg series
Hide thumbs Also See for USG40:
Table of Contents

Advertisement

Figure 256 Configuration > Network > Routing > Static Route > Add (IPv4 Configuration)
Figure 257 Configuration > Network > Routing > Static Route > Add (IPv6 Configuration)
The following table describes the labels in this screen.
Table 133 Configuration > Network > Routing > Static Route > Add
LABEL
DESCRIPTION
Destination IP
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
If you need to specify a route to a single host, enter the specific IP address here and use
a subnet mask of 255.255.255.255 (for IPv4) in the Subnet Mask field or a prefix of 128
(for IPv6) in the Prefix Length field to force the network number to be identical to the
host ID.
For IPv6, if you want to send all traffic to the gateway or interface specified in the
Gateway IP or Interface field, enter :: in this field and 0 in the Prefix Length field.
Subnet Mask
Enter the IP subnet mask here.
Prefix Length
Enter the number of left-most digits in the destination IP address, which indicates the
network prefix. Enter :: in the Destination IP field and 0 in this field if you want to send
all traffic to the gateway or interface specified in the Gateway IP or Interface field.
Gateway IP
Select the radio button and enter the IP address of the next-hop gateway. The gateway is
a router or switch on the same segment as your ZyWALL/USG's interface(s). The gateway
helps forward packets to their destinations.
Interface
Select the radio button and a predefined interface through which the traffic is sent.
Metric
Metric represents the "cost" of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The number need not be precise,
but it must be 0~127. In practice, 2 or 3 is usually a good number.
OK
Click OK to save your changes back to the ZyWALL/USG.
Cancel
Click Cancel to exit this screen without saving.
Chapter 11 Routing
ZyWALL/USG Series User's Guide
369

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents