ZyXEL Communications USG40 User Manual page 208

The following table describes the labels in this screen.
Table 62 Monitor > Wireless > Radio List
LABEL
More Information
#
AP Description
Model
MAC Address
Radio
OP Mode
Profile
Frequency Band
Channel ID
Station
Rx PKT
Tx PKT
Rx FCS Error Count
Tx Retry Count
Chapter 7 Monitor
DESCRIPTION
Click this icon to see the traffic statistics, station count, SSID, Security Mode and
VLAN ID information on the AP.
This field is a sequential value, and it is not associated with a specific radio.
Enter a description for this AP. You can use up to 31 characters, spaces and
underscores allowed.
This field displays the AP's hardware model information. It displays N/A (not
applicable) only when the AP disconnects from the ZyWALL/USG and the
information is unavailable as a result.
This field displays the MAC address of the AP.
This field displays the Radio number. For example 1.
This field displays the operating mode of the AP. It displays n/a for the profile
for a radio not using an AP profile.
AP Mode means the AP can receive connections from wireless clients and pass
their data traffic through to the ZyWALL/USG to be managed (or subsequently
passed on to an upstream gateway for managing).
This field displays the AP Profile for the Radio. It displays n/A for the radio profile
not using an AP profile. It displays default if using a default profile.
This field displays the WLAN frequency band using the IEEE 802.11 a/b/g/n
standard of 2.4 or 5 GHz.
This field displays the WLAN channels using the IEEE 802.11 protocols.
This field displays the station count information.
This field displays the data packets of incoming traffic on the AP.
This field displays the data packet of outgoing traffic on the AP.
This field displays the erroneous data packet count received and detected by
Frame Check Sequence (FCS)
This field displays the data packet count that were transmitted for retry.
ZyWALL/USG Series User's Guide
208