The Vpn Connection Add/Edit Screen - ZyXEL Communications USG40 User Manual

Table 208 Configuration > VPN > IPSec VPN > VPN Connection (continued)
LABEL
Remove
Activate
Inactivate
Connect
Disconnect
Object
Reference
#
Status
Name
VPN Gateway
Gateway IP
Version
Policy
Apply
Reset

29.2.1 The VPN Connection Add/Edit Screen

The VPN Connection Add/Edit Gateway screen allows you to create a new VPN connection
policy or edit an existing one. To access this screen, go to the Configuration > VPN Connection
screen (see
Chapter 29 IPSec VPN
DESCRIPTION
To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an IPSec SA, select it and click Connect.
To disconnect an IPSec SA, select it and click Disconnect.
Select an entry and click Object Reference to open a screen that shows which settings use
the entry. See Section 10.3.4 on page 286
This field is a sequential value, and it is not associated with a specific connection.
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
This field displays the name of the IPSec SA.
This field displays the VPN gateway in use for this VPN connection.
This field displays what IP version the associated VPN gateway(s) is using. An IPv4 gateway
may use an IKEv1 or IKEv2 SA. An IPv6 gateway may use IKEv2 only.
This field displays the local policy and the remote policy, respectively.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
Section 29.2 on page 539), and click either the Add icon or an Edit icon.
ZyWALL/USG Series User's Guide
for an example.
541