ZyXEL Communications USG40 User Manual page 302

Table 109 Configuration > Network > Interface > Cellular > Add / Edit (continued)
LABEL DESCRIPTION
User Name This field displays when you select an authentication type other than None. This field
is read-only if you selected Device in the profile selection. If this field is configurable,
enter the user name for this mobile broadband card exactly as the service provider
gave it to you.
You can use 1 ~ 64 alphanumeric and #:%-_@$./ characters. The first character must
be alphanumeric or -_@$./. Spaces are not allowed.
Password This field displays when you select an authentication type other than None. This field
is read-only if you selected Device in the profile selection and the password is included
in the mobile broadband card's profile. If this field is configurable, enter the password
for this SIM card exactly as the service provider gave it to you.
You can use 0 ~ 63 alphanumeric and `~!@#$%^&*()_-+={}|;:'<,>./ characters.
Spaces are not allowed.
Retype to This field displays when you select an authentication type other than None. This field
Confirm
is read-only if you selected Device in the profile selection and the password is included
in the mobile broadband card's profile. If this field is configurable, re-enter the
password for this SIM card exactly as the service provider gave it to you.
SIM Card Setting
PIN Code This field displays with a GSM or HSDPA mobile broadband card. A PIN (Personal
Identification Number) code is a key to a mobile broadband card. Without the PIN
code, you cannot use the mobile broadband card.
Enter the 4-digit PIN code (0000 for example) provided by your ISP. If you enter the
PIN code incorrectly, the mobile broadband card may be blocked by your ISP and you
cannot use the account to access the Internet.
If your ISP disabled PIN code authentication, enter an arbitrary number.
Retype to Type the PIN code again to confirm it.
Confirm
Interface
Parameters
Egress Enter the maximum amount of traffic, in kilobits per second, the ZyWALL/USG can
Bandwidth
send through the interface to the network. Allowed values are 0 - 1048576. This
setting is used in WAN load balancing and bandwidth management.
Ingress This is reserved for future use.
Bandwidth
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL/USG can
receive from the network through the interface. Allowed values are 0 - 1048576.
MTU Maximum Transmission Unit. Type the maximum size of each data packet, in bytes,
that can move through this interface. If a larger packet arrives, the ZyWALL/USG
divides it into smaller fragments. Allowed values are 576 - 1492. Usually, this value is
1492.
Connectivity Check The interface can regularly check the connection to the gateway you specified to make
sure it is still available. You specify how often the interface checks the connection, how
long to wait for a response before the attempt is a failure, and how many consecutive
failures are required before the ZyWALL/USG stops routing to the gateway. The
ZyWALL/USG resumes routing to the gateway the first time the gateway passes the
connectivity check.
Enable Select this to turn on the connection check.
Connectivity
Check
Chapter 10 Interfaces
ZyWALL/USG Series User's Guide
302