ZyXEL Communications USG40 User Manual page 203

The following table describes the labels in this screen.
Table 58 Monitor > Wireless > AP Information
LABEL
Add to Mgnt AP List
More Information
Reboot
Suppression On
Suppression Off
DCS Now
#
Status
Registration
IP Address
MAC Address
Model
Mgnt. VLAN ID (AC/AP)
Description
Station
Recent On-Line
Last Off-Line
The following table describes the icons in this screen.
Table 59 Monitor > Wireless > AP Information > AP List Icons
LABEL DESCRIPTION
This AP is not on the management list.
This AP is on the management list and online.
This AP is in the process of having its firmware updated.
Chapter 7 Monitor
DESCRIPTION
Click this to add new Access Points
Click this icon to see AP Information and Station count.
Select an AP and click this button to force it to restart.
Click this button to turn suppression on.
Click this button to turn suppression off.
Select one or multiple APs and click this button to use DCS (Dynamic Channel
Selection) to allow the AP to automatically find a less-used channel in an
environment where there are many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile berfore the
APs can use DCS.
Note: DCS is not supported on the radio which is working in repeater AP mode.
This field is a sequential value, and it is not associated with a specific AP.
This field displays the on-line or off-line status of the AP, move the cursor to the
AP icon and a status pop up message will appear.
This field displays the registration information of the AP. You can set the AP's
registration at Configuration > Wireless > Controller screen. APs must be
connected to the ZyWALL/USG by a wired connection or network.
This field displays the IP address of the AP.
This field displays the MAC address of the AP.
This field displays the AP's hardware model information. It displays N/A (not
applicable) only when the AP disconnects from the ZyWALL/USG and the
information is unavailable as a result.
This displays the Access Controller (the ZyWALL/USG) and runtime management
VLAN ID setting for the AP. VLAN Conflict displays if the AP's management
VLAN ID does not match the Mgmnt. VLAN ID(AC). This field displays n/a if
the ZyWALL/USG cannot get VLAN information from the AP.
This field displays the AP's description, which you can configure by selecting the
AP's entry and clicking the Edit button.
This field displays the station count information.
This field displays the latest date and time that the AP was logged on.
This field displays the date and time that the AP was last logged out.
ZyWALL/USG Series User's Guide
203