ZyXEL Communications USG40 User Manual page 438

Zywall/usg series

Hide thumbs Also See for USG40:

Table of Contents

Creating/Editing an Authentication Policy

Open the Configuration > Web Authentication > General screen, then click the Add icon or

select an entry and click the Edit icon in the Web Authentication Policy Summary section to

open the Auth. Policy Add/Edit screen. Use this screen to configure an authentication policy.

Figure 310 Configuration > Web Authentication > General > Add Authentication Policy

The following table gives an overview of the objects you can configure.

Table 161 Configuration > Web Authentication > General > Add Authentication Policy

Use to configure any new settings objects that you need to use in this screen. Select

Address or Schedule.

Enable Policy

Select this check box to activate the authentication policy. This field is available for user-

configured policies.

Enter a descriptive name of up to 60 printable ASCII characters for the policy. Spaces are

allowed. This field is available for user-configured policies.

Use this section of the screen to determine which traffic requires (or does not require) the

Authentication

senders to be authenticated in order to be routed.

Select the interface on which packets for this policy are received.

Source Address

Select a source address or address group for whom this policy applies. Select any if the

policy is effective for every source. This is any and not configurable for the default policy.

Select a destination address or address group for whom this policy applies. Select any if

the policy is effective for every destination. This is any and not configurable for the default

Select a schedule that defines when the policy applies. Otherwise, select none and the rule

is always effective. This is none and not configurable for the default policy.

Chapter 20 Web Authentication

ZyWALL/USG Series User's Guide

Show Quick Links

Table of Contents

Troubleshooting