Configuring The System Default Trunk - ZyXEL Communications USG40 User Manual

Table 125 Configuration > Network > Interface > Trunk > Add (or Edit) (continued)
LABEL
Spillover
OK
Cancel

10.12.2 Configuring the System Default Trunk

In the Configuration > Network > Interface > Trunk screen and the System Default section,
select the default trunk entry and click Edit to open the following screen. Use this screen to
change the load balancing algorithm and view the bandwidth allocations for each member interface.
Note: The available bandwidth is allocated to each member interface equally and is not
allowed to be changed for the default trunk.
Figure 249 Configuration > Network > Interface > Trunk > Edit (System Default)
Chapter 10 Interfaces
DESCRIPTION
This field displays with the spillover load balancing algorithm. Specify the maximum
bandwidth of traffic in kilobits per second (1~1048576) to send out through the
interface before using another interface. When this spillover bandwidth limit is
exceeded, the ZyWALL/USG sends new session traffic through the next interface. The
traffic of existing sessions still goes through the interface on which they started.
The ZyWALL/USG uses the group member interfaces in the order that they are listed.
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving.
ZyWALL/USG Series User's Guide
353