Vti Screen; Vti Add/Edit - ZyXEL Communications USG40 User Manual

10.10.2 VTI Screen

To access this screen, click Configuration > Network > Interface > VTI.
Figure 242 Configuration > Network > Interface > VTI
The following table describes the fields in this screen.
Table 121 Configuration > Network > Interface > VTI
LABEL
Configuration
Add
Edit
Remove
Activate
Inactivate
Object References
#
Status
Name
IP Address
vpn-rule
Apply
Reset

10.10.3 VTI Add/Edit

This screen lets you configure IP address assignment and interface parameters for VTI.
Note: You should have created a VPN tunnel for a Vpn Tunnel Interface scenario first.
To access this screen, click the Add or Edit icon in Network > Interface > VTI. The following
screen appears.
Chapter 10 Interfaces
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want
to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
Select an entry and click Object Reference to open a screen that shows which
settings use the entry.
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field displays the name of the LAG interface.
This field displays the current IP address of the virtual interface and subnet mask in
bits. If the IP address is 0.0.0.0, the interface does not have an IP address yet.
This shows the name of the associated IPSec VPN rule with Vpn Tunnel Interface
application scenario.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
344