Cruise Cancel Switch; Throttle Grip - Honda GL1800 Service Manual

CRUISE CONTROL SYSTEM

CRUISE CANCEL SWITCH

CLUTCH
• The lower switch is the clutch cruise cancel
switch.
Disconnect the clutch switch wire connectors and
check for continuity between the switch terminals.
There should be continuity with the clutch lever
squeezed and no continuity with the lever released.
Turn the ignition switch to "ON" and push the
cruise main switch to "ON."
Measure the voltage between the Black/yellow wire
terminal (+) and ground (–).
There should be battery voltage.
FRONT BRAKE
• The lower (large) terminals are the cruise cancel
switch terminals.
Disconnect the front brake switch connectors and
check for continuity between the switch terminals.
There should be no continuity with the front brake
lever squeezed and continuity with the lever
released.
Turn the ignition switch to "ON" and push the
cruise main switch to "ON."
Measure the voltage between the Black/blue wire
terminal (+) and ground (–).
There should be battery voltage.

THROTTLE GRIP

Remove the air cleaner housing (page 5-57).
Disconnect the throttle grip cruise cancel switch 2P
blue connector.
Check for continuity between the switch side con-
nector terminals.
There should be continuity with the throttle grip in
any position.
Turn the throttle grip to open the throttle, hold the
throttle drum then close the throttle grip. There
should be no continuity.
Turn the ignition switch to "ON" and push the
cruise main switch to "ON."
Measure the voltage between the Green/white wire
without the brown tube terminal (+) of the wire har-
ness side connector and ground (–).
There should be battery voltage.
21-14
P BLUE CONNECTOR