Driven Gear Boss Bearing Replacement; Output Shaft Disassembly/Inspection - Honda GL1800 Service Manual

GEARSHIFT LINKAGE/TRANSMISSION
DRIVEN GEAR BOSS BEARING
REPLACEMENT
Press the needle bearing out of the primary driven
gear boss.
TOOLS:
Driver
Attachment, 28 x 30 mm
Pilot, 28 mm
Press a new needle bearing into the driven gear
Install the needle
boss until the depth from the outer surface (oil
bearing with the
pump drive sprocket) is 3.5 – 4.0 mm (0.14 – 0.16 in)
stamped side
using the special tools.
facing up.
TOOLS:
Driver
Attachment, 32 x 35 mm
Pilot, 28 mm
OUTPUT SHAFT DISASSEMBLY/
INSPECTION
Turn the bearing outer race with your finger. The
bearing should turn smoothly and quietly.
Remove the following:
– snap ring
– retainer
– cotters
Press the output shaft out of the bearing using a
suitable collar (about 20 mm O.D.) and remove the
following:
– bearing
– gear bushing
– final driven gear
10-16
07749-0010000
07946-1870100
07746-0041100
07749-0010000
07746-0010100
07746-0041100
FINAL DRIVEN GEAR
DRIVER
EARING
RIVER
ATTACHMENT
EARING
ATTACHMENT
PILOT
PILOT
COLLAR
USHING