Antenna Removal/Installation; Antenna Inspection - Honda GL1800 Service Manual

AUDIO SYSTEM
ANTENNA
REMOVAL/INSTALLATION
Loosen the lock nut and remove the antenna from
the base by turning it counterclockwise.
Remove the seat (page 2-5).
AND
Open the trunk lid, and remove the four screws and
right trunk side pocket.
Remove the wire band.
Disconnect the antenna connector located under the
frame cross-member and remove the antenna wire
out of the frame.
Remove the three bolts, stay and antenna base
assembly.
ANTENNA CONNECTOR
Installation is in the reverse order of removal.
Route the wires
properly
TORQUE:
(page 1-23).
Antenna base bolt: 14 N·m (1.4 kgf·m, 10 lbf·ft)
ANTENNA
TAY
BOLT
LOCK NUT
IDE POCKET
BA E
CREW
INSPECTION
Remove the seat (page 2-5).
Disconnect the antenna connector.
Remove the antenna from the antenna base
(page 22-11).
B
Check for continuity between the antenna connector
and base as shown.
B
: Continuity
B: No continuity
22-11