Honda GL1800 Service Manual page 455

REAR WHEEL/SUSPENSION
8. Angle Sensor Power Input and Ground Line
Inspection at Angle
Remove the right saddlebag (page 2-15).
Disconnect the angle sensor connector.
Measure the angle sensor resistance between
the Black/red and Blue/green wire terminals of
the sensor side connector.
STANDARD: 4.0 – 6.0 kΩ (20° C/68° F)
Is the resistance within the specified value?
NO
YES
9. Angle Sensor Signal Line Inspection at Angle
Sensor
Remove the right saddlebag (page 2-15).
Disconnect the angle sensor connector.
Measure the angle sensor resistance between
the Yellow/red and Blue/green wire terminals of
the sensor side connector.
STANDARD: 0.4 – 5.4 kΩ (20° C/68° F)
Is the resistance within the specified value?
NO
YES
10. Suspension Level Relays Inspection
Check the suspension level relays and their cir-
cuits (page 14-29).
Does the suspension level relays and circuit
check OK?
NO
YES
14-10
– Faulty angle sensor; replace the shock
absorber assembly (page 14-16).
– • Open or short circuit in the Black/red
and Blue/green wires between the
combination meter 16P black con-
nector and angle sensor connector.
• Loose or poor contact of the angle
sensor connector.
– Faulty angle sensor; replace the shock
absorber assembly (page 14-16).
– • Open or short circuit in the Yellow/
red wire between the combination
meter 16P black connector and angle
sensor connector.
• Loose or poor contact of the angle
sensor connector.
– • Faulty suspension level relay(s).
• Open circuit in the wire harness.
• Loose or poor contact of the related
connectors.
– GO TO STEP 11.
ANGLE SENSOR CONNECTOR