Front Wheel Removal - Honda GL1800 Service Manual

FRONT WHEEL/SUSPENSION/STEERING
Install the holder cap onto the brake master cylinder
holder bolts.
Install the handlebar outer weight onto the inner
weight, aligning the bosses and grooves.
Install a new mounting screw and tighten it while
holding the weight.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install and secure the handlebar center cover with
the two screws.
Install the meter panel (page 2-7).
FRONT WHEEL
REMOVAL
Remove the front fender covers and front fender A
Be careful not to
(page 2-6).
damage the wheel
speed sensor and
Support the motorcycle securely using a hoist or
pulse ring.
equivalent and raise the front wheel off the ground.
• Do not operate the brake lever and pedal after
removing the brake caliper.
Cover both sides of the front wheel with protective
tape or an equivalent to prevent damaging it.
Remove the two mounting bolts (lower pivot and
Support the brake
upper joint bolts) and left front brake caliper.
caliper so that it
Remove the pivot collars from the fork and caliper
does not hang from
bracket.
the brake hoses. Do
not twist the brake
hoses.
13-16
HANDLEBAR CENTER COVER
OUNTING
BOLTS
LEFT CALIPER
)2
CREW
TAPE