Spark Plug Wire; Ignition Pulse Generator Replacement - Honda GL1800 Service Manual

SPARK PLUG WIRE

Disconnect the spark plug wires from the ignition
coils.
Remove the No. 3 & 4 ignition coil.
Remove the wire clamp from the stay and remove
the stay from the No. 2 and No. 5 spark plug wires.
Remove the cylinder head side covers (page 3-7).
Disconnect the spark plug caps from the plugs
(page 3-8).
Remove the bolts, front lower inner cover, wire
clamps and the spark plug wires.
Route the spark plug wires properly (page 1-23) and
install the removed parts in the reverse order of
removal.
IGNITION PULSE GENERATOR
REPLACEMENT
Remove the following:
– front lower fairing (page 2-6)
– air cleaner housing (page 5-57)
Disconnect the ignition pulse generator 2P red
connector.
Remove the 12 bolts and the crankcase front cover.
Remove the dowel pins and gasket.
IGNITION SYSTEM
SPARK
PLUG
WIRES
WIRE CLAMP
SPARK PLUG APS
LAMP
INNER OVER
P RED CONNECTOR
RONT CRANKCASE COVER
o. 3 & 4
IG ITIO COIL
LAMP
BOLTS
SIDE OVER
BOLTS
18-9