Honda GL1800 Service Manual page 510

Hide thumbs Also See for GL1800:

Table of Contents

Connect the brake hoses to the caliper with the oil

Route the brake

bolts and new sealing washers, and tighten the oil

hoses properly

(page 1-23).

TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)

Tighten the pad pin and install the pad pin plug.

TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)

Perform the speed sensor air gap inspection

ABS model only:

(page 16-29).

LEFT CALIPER

OWER PIVOT CO AR

Apply grease to the lower pivot bearing and dust

seal lips, and to the outer surface of the upper pivot

Install the pivot collars into the fork and caliper

Install the left brake caliper so the disc is positioned

between the pads, being careful not to damage the

Install new mounting bolts (lower pivot and upper

joint bolts) and tighten them.

TORQUE: Pivot bolt: 31 N·m (3.2 kgf·m, 23 lbf·ft)

EFT FRONT BRAKE CA IPER

Joint bolt: 25 N·m (2.6 kgf·m, 19 lbf·ft)

BRAKE SYSTEM (Standard)

EALING WA HER

UPPER PIVOT CO AR

SEA ING WASHERS

Troubleshooting